User manual

PART 1 • English
11
English
6.3 Accessing the favourite channels
1. Press OK to enter channel list.
2. Press tu to select the desired favourite group.
3. Press pq to select the favourite channel.
A.1 TROUBLESHOOTING
There may be various reasons for the abnormal operation of the receiver. Check the receiver according to the procedures
shown below. If the receiver does not work properly after checking it, please contact the dealeror the local Service Hotline.
Do NOT open the receiver cover. It may cause a dangerous situation and the warranty will get void.
Problem Possible cause What to do
IR sensor light not lit Mains lead unplugged/multipoint connector switched
off
Mains fuse blown
Check mains lead /switch multipoint connector on
Check fuse
No signal found Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to switch
ON antenna power/
external feed
Check aerial lead
Check aerial
Check with dealer
Switch receiver’s Antenna Power
ON/ connect external
feed
No picture or sound on TV SCART is not selected on your TV
TV or VCR are not connected to main
The TV is not tuned to the signal of the receiver
Switch to correct TV input
Check mains lead
Tune the TV to the receiver signal.
Scrambled channel message Channel is scrambled Select alternative channel
No response to remote
control
Receiver off
Handset not aimed correctly
Front panel obstructed
Hand set batteries exhausted
Plug in and turn on plug
Aim handset at front panel
Check for obstructions
Replace handset batteries
Forgotten channel lock code Re-install channels to cancel
channel lock
Forgotten menu lock code
Contact local Service Hotline or send email to our
Support via www.strong.tv
After moving the receiver
to another room you are no
longer able to receive
digital reception
The aerial feed former new point may come through a
distribution system which may reduce the digital signal
now received by the box.
Try a direct feed from the antenna
The receiver switches off
automatically.
Auto Standby function enabled. Disable auto standby. See section 5.3.4 for details.
A.2 TECHNICAL SPECIFICATIONS
Demodulator
Demodulator: 16-QAM/64-QAM, QPSK
Transmission mode: 2 K - 8 K
Video Decoder
Profile level: MPEG-2 MP@ML
Video resolution: 720 x 576 pixels (PAL), 720 x 480 (NTSC)
Decoding & Video Out: PAL & NTSC
Aspect ratio: 4:3 Letterbox, 4:3 Pan & Scan, 16:9
Audio Decoder
MPEG MusiCam Layer II
Sampling rate: 32, 44.1, 48 KHz
Audio mode: Stereo, Joint Stereo, Dual Mono, Mono
Tuner
Front End: DVB-T, UHF & VHF Tuner
Input frequency range:
174 ~ 230 MHz (VHF) and
470 ~ 862 MHz (UHF)
Loop through frequency range:
47 ~ 862 MHz
Input signal level: -78 ~ -20 dBm
Memory and System
Flash memory: 1 MByte
SDRAM: 16 Mbytes
RF Modulator
Standard: PAL-BG,-I, DK-\ NTSC
Channels: 21 ~ 69 selectable via OSD
Multimedia
Audio playback: MP3 and WMA formats
Picture view: JPEG and BMP format
Connectors
ANT IN: IEC Female
TO TV (inc. modulator): IEC Male
LOOP IN, LOOP OUT
TV SCART (RGB, CVBS)
VCR SCART (CVBS)
3 RCA (Video, Audio Left & Right)
S/PDIF: coaxial output
USB port