User manual
PART 1 • English
4
2.3 Rear Panel
Fig. 2
1. ANT IN To connect an antenna for reception of broadcasting signal.
Supports active antennas with 5V DC.
2. TO TV (inc. modulator)
To connect to the terrestrial antenna input of your TV set. or e.g. VCR/DVD recorder.
This connection will allow you to watch analogue & digital terrestrial broadcasts
3. LOOP IN modulator loop through input.
4. LOOP OUT To connect to the LOOP IN
5. TV SCART To connect your receiver with your TV set using a SCART cable.
6. DVD/VCR SCART
To connect to a Video or DVD recorder
7. Audio L/R and Video Connector
To connect your receiver with your TV set using an A/V cinch cable.
8. S/PDIF Coaxial
To connect your receiver to a digital audio amplifier.
9. Power Cord Your receiver requires a voltage of 100-240V AC (Auto-selectable), 50/60Hz +/-5%. Make sure to
check the power specification before connecting your receiver to the wall outlet.
2.4 Remote Control
Fig. 3
1.
Turns the receiver On/Standby
2.
Mutes audio output of the receiver
3. 0~9 Channel selection or value input
4. FAV Favourite group selection
5. RCL Back to previous shown channel
6. MENU Opens the main menu/ To get back one step in the menu
7. EXIT Exits from the menu or sub-menu
8. pq Change channel to previous/next.
In menu: Moves the cursor up/down.
9. tu Increases/decreases the volume level.
In menu: Change value for selected setting
10. OK Displays the current channel list
In menu: Activates the highlighted menu item.
11. EPG Shows the EPG (Electronic Program Guide) in TV mode
12. INFO Shows the actual channel information
13. 4 Records the TV program to the connected storage device
14. TXT Shows teletext on OSD (On Screen Display)
15. TV/R Toggles between TV and RADIO mode
16. 3 STOP
17. 2 Pause
18. 5, 6 Fast rewind / Fast forward
19. u Play
20. LIST Shows a list of recordings on the connected USB storage device
21. AUDIO Sets the current audio channel to left, right or stereo
22. SUB Shows list of available subtitle languages
23. AV To switch between TV and VCR mode
24. COLOURED BUTTONS are for Teletext functions
3.0 CONNECTION
3.1 Connecting to a Terrestrial Antenna
Fig. 4
To receive the broadcast signal, the terrestrial antenna cable should be connected to the ANT IN connector at the back of
the receiver.