User manual

PART 1 • English

English

1.3 Equipment Set-up

We recommend you consult a professional installer to set up your equipment. Otherwise, please

follow the instructions below:

nRefer to the user manual of your TV and your antenna.

nMake sure that the SCART cable and outdoor components are in a good condition and

the SCART connections are well shielded

This manual provides complete instructions for installing and using this receiver. The following

symbols will serve as follow.

WARNING: Indicates warning information.

Tips: Indicates any other additional important or helpful information.

MENU Represents a button on the remote control or the receiver (Bold Character)

Move to Represents a menu item within a window. (Italic Character)

1.4 Accessories

nUser’s Manual

n1 Remote control unit

n2x Batteries (AAA type)

Note: The batteries should not be recharged, disassembled, electrically short-circuited,

be mixed or used with other types of batteries.

1.5 Usage of external USB devices

nIt is recommended to use USB 2.0 storage devices. If your device is not compatible to

USB 2.0 speciﬁcations, multimedia functions of the receiver would not work properly.

nSTRONG cannot guarantee compatibility to all types of USB storage devices.

nIt is advised not to store important information on USB storage devices used with the

receiver. Always make backups of data on USB storage device before usage with receiver.

STRONG will not take responsibility for any loss of information or circumstances caused

by loss of information.

2.0 YOUR RECEIVER

2.1 Rear Panel

Fig. 2

1. SAT OUT To connect an extra receiver to the satellite signal from dish

2. SAT IN To connect to the LNB for satellite signal from dish

3. TV SCART To connect to your TV set using a SCART cable.

4. S/PDIF Digital audio output To connect to the input of your digital audio ampliﬁer.

5. Power Cord Your receiver requires a current of 100~240 V AC (Auto-selectable),

50/60Hz ±5%. Make sure to check the power speciﬁcation before

connecting your receiver to the wall outlet.