User manual

PART 1 • English
14
Cause Remedy
No picture The receiver can’t receive the signal Check the antenna cable, replace
the cable, or connect the cable to
the receiver tightly.
Incorrect values of some tuner
parameters.
Set the values of the tuner
parameters correctly in the
installation menu.
Wrong direction of the dish Check the signal strength with a
spectrum analyzer and adjust your
dish correctly.
Receiver tries to start-
up, switches ON/
OFF/ON/OFF… or
displays “LOAD”
Receiver detected short cut in your
cable system or detected “Antenna
Power Overload”.
Disconnect receiver from main power
Check your cable system. Remove
short cut.
Replace LNB.
Restart receiver.
The remote control
does not work
The batteries of the remote control
are not inserted or exhausted
Check whether the batteries are
inserted correctly in your remote
control. Check the batteries, and if
exhausted replace the batteries in
the remote control.
The USB storage
device is not
recognized.
Wrong formatted Format USB device by receiver in
menu “Recording Device”
The external USB
HDD does not start.
Power consumption is too high. Connect extra power supply adaptor
to your USB HDD.
The receiver switches
off automatically.
Auto Standby function enabled. Disable Auto Standby. See section
5.3.1.4 for details.
A.2 SPECIFICATIONS
General Data:
Input Voltage Range: 100-240 V AC 50/60 Hz
Power consumption: max 20 W (with external memory device)
Stand-by power consumption: 1.00 W (without external memory device)
Operating Temperature: +0°C ~ 40 ° C
Storage Temperature: -30°C ~ 80°C
Operating Humidity Range: 10% - 85%, RH, Non-condensing
Size (WxDxH) in mm: 230 x 165 x 45
Weight: ca. 0,8 kg