User manual

PART 1 • English
9
English
requested satellites and connect the LNB’s with coaxial cables to the input connectors of the DiSEqC 1.0
switch. Connect the output connector of the DiSEqC 1.0 switch to the SAT IN of TUNER 1 connector at
the back of your receiver. Connect one end of LOOP cable to the SAT OUT of TUNER 1 and another end of
LOOP cable to the SAT IN of TUNER 2. Use connection type LOOP THROUGH.
NOTE: You can make duplicated installation of 2 or more satellites. Use for this purpose TWIN LNB on
the dishes and setup connection type TUNER 1&2. (Connection diagram shown on Fig. 9)
Connecting a dish on a motorized positioner to your receiver (Fig. 9)
Another possibility for watching programs from multiple satellites is by mounting a dish to a motorized
DiSEqC 1.2 Positioner. Have your dealer mount the dish to the Positioner, set the correct angle of the
elevation and let him set the centre point for your Positioner. Connect the LNB with a coaxial cable to the
LNB input connector of the Positioner, and connect the output of the Positioner to the SAT IN connector
of TUNER 1 at the back of your receiver. Connect one end of LOOP cable to the SAT OUT of TUNER 1
and the other end of LOOP cable to the SAT IN of TUNER 2. Use connection type LOOP THROUGH.
3.4 Connecting to computer via serial cable for downloading software
Connect the RS232 connector on the back of your receiver to the Serial port of your computer using a
serial cable (Fig. 10). Instructions how to download software can be found on our website
www.strong.tv (support > download). There you can find as well a nice channel edit tool for preparing
your own Favourite- and Channel lists. However, this receiver can download new system software
automatically by satellite.
4.0 STARTING UP FOR THE FIRST TIME
Ensure that your satellite receiver is correctly connected to your TV and Satellite dish. Make sure your satellite
signal has the best possible quality. If you are not sure about this then ask your local STRONG dealer to check your
installation or satellite signal. Confirm that the power plug of receiver is plugged into the wall outlet. Turn on the
receiver. The Installation Wizard will appear on screen when you power on the receiver for the first time.
It is recommended that you do first time installation by following the Installation Wizard step by step. It will help you
easily achieve system configuration and channel installation. . Advanced users can skip the wizard by pressing the
MENU button and set-up channels using the Installation menu.
4.1 Language Selection
Use pq buttons to select your preferred language and press OK to confirm. The SET-UP WIZARD menu
will appear. It describes functional buttons that should be used during installation. Once you’ve read the
information press OK to continue.
4.2 Select connection type
Use the tu buttons to select your connection type. Make sure to select connection type according to the
antenna installation. Please notice the help text on the screen.