User manual

PART 1 • English
13
English
Dish position: This item value depends from the mode of the Dish.
If mode of selected dish is “Fixed” then this item is not selectable
If mode of selected dish is “DiSEqC 1.2” then value can be “Not stored” (in case
dish position for selected satellite was not stored”) or in range from 1 to 64 if
position has been stored. Select item and press OK to setup Positioner. For more
information about Positioner setup see chapter 5.2.1.1.
If mode of selected dish is “GOTO X” then value is “GOTO X”. Select item and
press OK to setup
GOTO X function: more details read in chapter 5.2.4.
Transponder: Move focus of the menu to this item and press OK. List of transponders of
selected satellite will appear at right side of the screen. You can select transponder
in order to check signal strength and quality of reception. Transponder list contains
predefined transponders. If you need to modify transponder list please use
menu “Edit satellites” as described in chapter 5.2.3. If you need to scan specific
transponder then use Manual scan as described in this chapter below.
Network search: If this item is set to “OFF” then the receiver will search for the channels that are
available in the preset transponder list of the selected satellite. If this item is set
to “ON” then the receiver will search for additional information about available
transponders from the satellite. This option is useful to get new channels from
transponders which were added to the satellite later.
NOTE: ASTRA and HOT BIRD (partially) provide a NIT (network information table), but this
service is not available at every satellite.
Search for: You can select type of the channels that will be installed to your receiver.
If “All channels” is selected, then the receiver will install Free-To-Air and Scrambled channels.
If “Scrambled” is selected, then the receiver will install only Scrambled channels.
If “FTA” is selected, then the receiver will install only Free-To-Air channels.
Once you’ve completed all settings you can start the channel search process.
Press the RED button to setup channels from all transponders of the satellite;
Press the GREEN button to setup channels from the selected transponder;
Press the YELLOW button to enter the “Manual channel search” menu to search manually for
channels on a specific transponder or to setup a single channel with known Video and Audio PIDs.
Manual setup of channels
In Manual channel search menu you can setup all channels from specific transponder or single channel.
To setup all channels from specific transponder:
Satellite: Indicates name of the satellite where channels will be searched
Frequency: Use Numeric buttons to enter the frequency of a transponder
Polarisation control: Use tu buttons to select polarisation of transponder
Symbol rate: Use Numeric buttons to enter symbol rate value
Network search: Use tu buttons to select ON or OFF
Search for: Use tu buttons to select type of channels to be installed
Press RED (Search) button to start channel search.