User manual

English

PART 1 • English

Video Output

This setting is only relevant when the receiver is connected to the TV set via Scart. Select RGB for the

best picture quality or CVBS if your TV doesn’t support RGB.

Loop Through (VCR to TV Scart)

This option is only relevant if you have a device (video-/DVD-recorder) connected to the VCR scart

connector of your receiver. Its signal will be looped through to the TV scart output of your receiver. Use

this option to set the preferred loop-through mode.

Running mode: The Loop through will be switched off when the receiver is in the

standby mode.

Always: The Loop through is always on – in operation and in the standby mode.

By pressing the DTV/VCR button on the remote control you can switch between DTV/VCR contents in

operation mode. “AV IN” will be displayed on the front LED display when the receiver is in VCR mode.

Press the DTV/VCR button again to return to the digital TV content.

NOTE: The setting "Always" increases the power consumption in standby mode. The front

panel LED remains green in standby!

7.3 Channel Search

To access the menu press MENU and select Channel Search. It contains two options: Installation and DB

(Data Base) Management. Select an option and press OK to enter it. Press EXIT to exit the menu.

7.3.1 Installation

7.3.1.1 Satellite Selection

Use the pq buttons to highlight the satellite your dish is aimed at. Its antenna settings will be shown at

the right side. You can enter the right side with the tu buttons and return to the satellite list with EXIT.

7.3.1.2 Conﬁgure the antenna settings for the selected satellite

LNB Type: Press tu or OK to show the list of LNB Types which is shown as frequencies.

You also can enter customized frequencies by User Single or User Dual at the

bottom of the list. The default setting Universal LNB (09750/10600) – the most

used on the market.

LNB Power: Use tu to set the LNB power. 13/18V is the setting for a Universal LNB.

22KHz: Use tu to switch the 22KHz oscillator signal on or off. Auto is the setting for a

Universal LNB.

Toneburst: To enable or disable the toneburst switcher if available.

DiSEqC1.0: To select the right port from up to 4 (if available) for the right LNB.

DiSEqC1.1: To select the right port from up to 16 (if available) for the right LNB.

Motor: If using a motor, press tu to choose between DiSEqC1.2 and GOTOX

depending on the motor type you use. Then press OK to show the menu for

setting the position or GREEN for location.

DiSEqC1.2: Move the motor to the right position for locking the signal like explained below.