User manual

English

PART 1 • English

and press BLUE for Scan. A window with scanning settings will be displayed.

After conﬁguring the settings like explained in Single Satellite Scan above, press

OK or BLUE again to start Multi-Scan on all selected satellites.

7.3.1.4 Scanning by transponder (Manual Scan)

Press GOTO for displaying the transponder list of the highlighted satellite. By pressing GOTO again you

switch back to the satellites list.

Single Transponder Scan: Use the pq buttons to highlight the transponder you want to scan. Press

BLUE for Scan. A window with scanning settings will be displayed. After

conﬁguring the settings (explained in 7.3.1.3 above), press OK or BLUE again

to start the scanning of the highlighted transponder. When the scan progress

has been completed, all found channels will be stored and the receiver will

switch to the ﬁrst found channel.

Multi-Transponder Scan: Select the transponders you want to scan with the OK button. The selected

transponders will be marked with the "ü“ symbol. Press BLUE for Scan. A

window with scan settings will be displayed. After conﬁguring the settings like

explained in 7.3.1.2 above, press OK or BLUE again to start Multi-Scan on all

selected transponders.

7.3.1.5 Satellite Edit options

Add satellites: Press RED to add a new satellite. In the pop-up banner, enter the satellite's

name and position by using the navigation and numeric buttons.

Satellite Name: Press OK to enter text input mode. In the key table select a character by using

the navigation buttons. Press OK to enter the chosen character. When you have

entered the name, navigate to the “OK” button on screen and press OK on the

remote control to conﬁrm the new name. Save the settings with OK or cancel

by EXIT.

Edit satellites: Press GREEN to edit the focused satellite. For changing settings see

explanation above. Conﬁrm changes with OK or cancel by EXIT.

Delete satellite: Press YELLOW to delete the focused satellite. Press OK to conﬁrm deleting or

EXIT to cancel.

7.3.1.6 Transponder Edit options

NOTE: Transponders can only be edited when the transponder list is on screen. To do this,

select the satellite you want to edit and press GOTO to open the TP list. The options

below are now available.

Add transponder: Press RED to add a new transponder. In the pop-up banner, enter the

transponder´s data by using the navigation and numeric buttons. Conﬁrm the

settings with OK or cancel with EXIT. An existing TP cannot be stored again

under the same satellite.