User manual

English
PART 1 • English
19
Auto Standby
Auto standby is a new, power saving feature that helps you reduce power consumption. It will switch
off the receiver when no command is given for the defined period of time. It is set per default to 180
minutes. With the tu buttons you can select between different time intervals or Off for disabling the
feature. In the 0000 mode you can enter the auto standby time with the 0~9 buttons.
NOTE: If there are timers running, the auto standby function will be disabled for the
booked time.
7.7 USB
Press MENU and select USB. The menu provides the Multimedia feature for playback of Music, Photo and
Movie. The different file formats listed below are supported. In this menu you can also see information
about the total and free space of the connected USB device, make video and photo configurations and
format the USB device into a format accepted by the receiver. The unit supports USB devices with FAT
and FAT32 format. Make sure your USB device is formatted correctly.
NOTE: STRONG cannot guarantee compatibility (operation and/or bus power) with all USB
mass storage devices and assumes no responsibility for any loss of data that may occur
when connected to this unit.
With large amounts of data, it may take longer for the system to read the contents of a
USB device.
Some USB devices may not be properly recognized. Even when they are in a supported
format, some files may not play or display depending on the content.
7.7.1 Multimedia
If there is no USB device plugged in, a warning message "No USB Device is Found" will be displayed.
When a USB device is detected you can select between Music, Photo and Movie in this menu. Select one
of them, press OK to enter the file browser and select the file you want to play.
Music – supported file formats are MP3 and WMA.
Photo – supported file formats are JPG and BMP
Movie – supported video files in various formats (MPG, MPEG, TS, VOB, MP4, AVI,...)*
Music
Select a music file and press OK to start playback.
During playback, following functions are available:
u or OK: Start playback of the selected file.
2: To pause/resume playback and 3 to stop it.
5 6: To rewind or forward playback in x2, x4, x8, x16 and x32 speed. When it has fast
rewinded to the beginning, playback of the current file will be resumed. When it
has fast forwarded to the end, playback of the next file starts.
GOTO: Opens a counter banner for entering the time moment you want to jump to.
Use the 0~9 buttons for entering the time and OK to confirm.
7 8: Start playback of the previous/next file.