User manual
9
English
PART 1 • English
4.1 Installation
4.1.1 Satellite Setting
Press pq to highlight the satellite your dish is aimed at. When using a multi feed antenna with more
than 1 LNB, select the satellites your antenna is adjusted for by pressing the OK button and set the
appropriate DiSEqC input for the LNBs Astra 19.2E and Hotbird 13E are pre-selected on DiSEqC 1 and
2. The scan process will then search on all selected satellites.
If you have a non-standard setup, then please refer to section 7.3.1.2 of this manual: Congure the
antenna settings for the selected satellite.
4.1.2 Signal Adjust
The signal quality bar on the bottom of the screen allows you to fine tune the alignment of your
antenna for optimum reception. Adjust your antenna for maximum possible signal quality. When the
signal cannot be improved anymore, fix the dish on this position and press the GREEN Scan button
to continue.
4.1.3 Automatic SAT scan
Press pq tu to highlight the options of choice and press GREEN Scan to start the channel search.
It is recommended to use the default settings.
For details, please refer to section 7.3.1.3 of this manual: Automatic SAT scan
4.1.4 Channel Search
Your receiver will now perform an automatic channel search. When the process has been completed,
all found channels will be stored and the receiver will switch to the first found channel. You are now
ready to enjoy your new receiver.
NOTE: If no channels were found during the automatic channel scan, the receiver will return to the
Installation menu. Please select your language again and refer to chapter 7.3 for further instructions.
5.0 QUICK GUIDE FOR USING YOUR RECEIVER
We at STRONG understand that you can’t wait to enjoy your new HD receiver. The following quick
guide will make you familiar with the basic operation of this device. We do, however, advice you to
read the full manual to get the best performance from your STRONG HD receiver.
To turn your receiver ON or to Standby, press the q button on the remote control.
Choose channels with the pq buttons. Alternatively, you can also enter the channel number with
the 0~9 buttons on the remote control or press OK in viewing mode to display the channel list.
The volume can be adjusted with the tu buttons.
6.0 OPERATION
In viewing mode, several features are available to make watching TV a true pleasure. This paragraph
describes these features. Please also read chapter 7 to get familiar with the menu of your new
receiver.
6.1 Changing channels
There are different ways to change channels with your new receiver.