User manual

7
PART 1 • English
English
4.6 Channel Setup
Your receiver will now perform an automatic channel search. Once the process is finished, all found
channels will be stored and the receiver will switch to the first found channel. You are now ready to enjoy
your new receiver.
Note: If no channels were found during the automatic channel scan, the receiver will
display the Satellite Settings menu. Please refer to chapter 7.1.1 for instructions.
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at STRONG understand that you can’t wait to enjoy your new HD receiver. The following quick guide
will make you familiar with the basic operation of this device. We do, however, advice you to read the full
manual to get the best performance from your STRONG HD receiver.
To turn your receiver ON or to Standby, use the q button on the remote control or the button on the left
side of the front panel.
Choose the desired channel with the pq buttons or the P+/P- buttons. Alternatively, you can digit the
channel number with the [0~9] buttons on the remote control. Or press OK in viewing mode to display
the channel list.
The volume can be adjusted with the V+/V- buttons or the tu buttons.
6.0 OPERATION
In viewing mode, several features are available to make watching TV a true pleasure. This paragraph
describes these features. Please also read chapter 7.0 to get familiar with the menu of your new receiver.
6.1 Changing channels
Your new receiver is equipped with three ways to change channels.
 via direct access
 via the channel list and
 via the P+/P- keys.
6.1.1 Direct access
To gain direct access to a certain channel, simply input its number with the [0~9] key’s on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits is
possible. Just wait a few seconds and your receiver will switch to the selected channel.
6.1.2 Channel list
Press OK in viewing mode to display the Channel List. Use pq in the Channel List to highlight your
channel of choice and press OK once to select the highlighted channel. Press OK again to leave the
Channel List. The Channel List is equipped with a filter function to make finding your favourite channels
easier. While in the Channel List, press RED. An alphabet banner will now be displayed. Use pq to select
the first letter of the desired channel and OK to confirm. All channels beginning with the chosen letter
will now be displayed.