User manual

6
PART 1 • English
4.0 STARTING UP FOR THE FIRST TIME
Ensure that your satellite signal is of good quality and that all connections are sound. In case of
difficulties or questions, please ask you local dealer for assistance. It is recommended to follow the Setup
Wizard step by step. It will guide you through the basic installation and channel searching process. You
can enjoy digital HD broadcasts within just a few minutes.
4.1 Language selection
After turning on the power for the first time, the language selection menu will appear. Choose your language
with pq and confirm with OK. A welcome screen will now be displayed. Once you are ready, press OK to
start the wizard. During any stage of the Setup Wizard, you can press EXIT to get back to the previous screen.
4.2 System Setup
Here you can set the Country, Aspect Ratio, Conversion Mode and Subtitle Language. Use pq to move
the highlight and tu to change settings. To see a list of all possible settings for the highlighted option,
press OK. Once all settings are made, move the highlight to NEXT and press OK to continue.
4.3 Satellite Selection
Use pq to highlight the satellite your dish is aimed at and press OK to confirm.
If your dish is aimed at Astra 1C, 1E, 1F, select ASTRA 19.2E. The SCAN MODE screen will appear.
If your dish is aimed at HOT BIRD, select HOTBIRD 13E.The SCAN MODE screen will appear.
If your dish is aimed at another satellite, select OTHER. You will be guided to the Satellite Settings menu.
Refer to chapter 7.1.1 for instructions.
Note: If Germany is chosen as country and ASTRA 19.2E as satellite, German pre-
installed channels are available. An extra screen will then be displayed giving a
choice between Preinstalled & Scan and Satellite Scanning. Choose Preinstalled &
Scan to install the German pre-installed channels and continue with the Setup
Wizard as described from point 4.4 or choose Satellite Scanning to continue
without pre-installed channels.
4.4 Scan Mode
Use pq to highlight the desired option and press OK to confirm.
All: Will scan all available channels on the chosen satellite.
Free: Will scan FTA (Free-To-Air) channels only.
4.5 Signal Adjust
This screen allows you to fine tune the alignment of your dish antenna for optimum reception.
Use tu to select the switch input the dish is connected to. (If the LNB of your dish is directly connected
to the receiver, choose Switch Input 1) The bars on the bottom of the screen indicate the current signal
strength and quality. A red bar indicates a bad signal. Green bars indicate a good signal. Yellow bars
indicate that the signal condition is nearly acceptable.
Adjust your dish for maximum possible signal quality and strength. Once the signal cannot be improved
anymore, fix the dish on this position and press OK to continue.