Operation Manual

PART 1 • English
11
English
Connecting to component output
1. Make sure to use proper cable (3 RCA on each side of cable, usually coloured as Green, Blue, Red).
2. Connect chinches at one side of the cable to Y, Pb, Pr (Green, Blue, Red) outputs on your
receiver and another side of the cable to corresponded inputs on your TV. Very important to
follow colour mark.
Figure 7
Connecting by SCART cables
1. Connect the TV SCART connector at the back of the receiver to the SCART IN connector on
your TV set or connect Video RCA and Audio L/R RCA connectors at the back of the receiver
to corresponded inputs on your TV set.
2. Connect the VCR SCART connector of the receiver to the SCART-IN connector on your VCR set.
(Figure 7)
NOTE: Please, make sure that your receiver is connected by SCART or 3 RCA cable (Video,
Audio L/R) to your TV set when you connect your VCR (or DVD) to receiver. You will not
get video signal from your VCR (DVD) through the receiver if your receiver is connected
only by HDMI or Y, Pb, Pr connector to your TV set.
3.3 Connecting to Digital Audio Amplifier
Connect S/PDIF connector at the back of your receiver to appropriated input of your Digital Audio
Amplifier. (Figure 6)
3.4 Connecting to computer by serial cable
Connect the RS-232 connector on the back of your receiver to the Serial port of your computer using a
serial cable. Instructions how to download software can be found on our website www.strong.tv (support
-> download). However, this receiver can download new system software by OTA update from satellite.