Operation Manual

PART 1 • English
12
3.5 Connecting to external USB - Harddisk
Switch on your external HDD (connect the power adapter if applicable) before you connect the USB connector
at the back of your receiver. After finishing the First Installation (Cap. 4.0) proceed with following steps:
1. Unless the USB-Hard disk is already formatted in FAT32 and recognised successfully for the first
time you will get a message to format your device to FAT32 in “Application” >”USB” menu.
2. In this menu press the YELLOW (Format) button on your remote control to confirm. After ~10 to
20 sec. formatting will be finished and you can leave the menu with the MENU or EXIT button.
3. Go to “Application” ->”PDR”
menu to adjust the preferred recording duration.
4. Set
Timeshift to OFF or ON as desired.
Important: During formatting all data on the hard disk will be deleted and get permanently lost.
STRONG cannot be granted for any loss or damage of data, if you format the hard disk.
4.0 STARTING UP FOR THE FIRST TIME
Ensure that your satellite receiver is correctly connected to your television and dish and your satellite
signal is of good quality. Ask your local STRONG dealer to check your installation or satellite signal if you
are not sure how to do this.
Confirm that the power plug of receiver is plugged into the wall outlet. Turn on the receiver by power
switch on rear panel.
The language section menu will be shown on your TV Screen.
It is recommended that you do first time installation following Installation Wizard step by step.
It will help you easily achieve system configuration and channel installation. If you are advanced user
then you can skip wizard by pressing EXIT button and set-up channels using Installation menu.
4.1 Language Selection
Press OK to choose the language.
4.2 Select Satellite
The Installation Wizard preconfigured for easy installation of ASTRA 1C, 1E (19E) or HOT BIRD (13E). For these
satellites LNB configuration is predefined as Universal LNB connected to the receiver via DiSEqC 1.0 switch input
1. If your dish is aimed to ASTRA 1C, 1E (19E) or HOT BIRD (13E) then select corresponded satellite from the
list (future steps of installation are described in 4.3). If your dish is aimed to another satellite or you have multiple
dish installation then select other (future steps of installation are described in 4.4).