Operation Manual

PART 1 • English
15
English
Lock
Lock function can be used in order to block access to some channels. Press GREEN button to lock/
unlock channel of your choice. Locked channel will be marked by Lock symbol. In order to watch locked
channel you will need to enter PIN code. Channel will be locked in all channel lists.
Delete
Pressing YELLOW button will mark selected channel to delete. To unmark channel select it and press
YELLOW button again. Channel(s) will be deleted after you press BLUE button. Be aware: after pressing
BLUE button channel(s) will be deleted from all channel lists. To cancel delete operation you can press EXIT
button. Message “Do you want to save?” will appear on screen. Press EXIT to cancel or OK to confirm.
5.2 Satellite Search
The Satellite Search menu contains following sub-menus:
Channel set-up allows you to setup channels from selected satellites.
Dish Set-up allows you to setup configuration of your dishes.
Edit satellites allows you to edit predefined satellites and their transponders as well as add new satellites.
GOTO X setup allows you to setup your location in order to use GOTO X type of positioner.
5.2.1 Channel set-up
From this menu you can setup channels from satellite(s) in several modes, access to
Dish setup menu,
Positioner setup (if used).
Satellite:
Move focus of the menu to this item. Press OK to display list of available satellites.
Select satellite of your choice and press OK. If satellite doesn’t exist in the list you
should add it first using
Edit satellites menu.
Dish number: move focus of the menu to this item. Use tu buttons to select dish number to which
above selected satellite belongs to. Press OK button to enter to Dish setup menu. Dish
number “----“ means that selected satellite do not belongs to any dish.
Dish position:
This item value depends on the mode of the Dish.
If mode of selected dish is Fixed then this item is not selectable.
If mode of selected dish is DiSEqC 1.2 then value cannot be stored (in case dish
position for selected satellite was not stored) or in range from 1 to 64 if position has
been stored. Select item and press OK to setup positioner. See chapter 5.2.1.1 for more
details about Positioner setup. If mode of selected dish is GOTO X then value is GOTO X.
Select item and press OK to setup GOTO X function.
Transponder: Move focus of the menu to this item and press
OK. List of transponders of selected
satellite will appear at right side of the screen. You can select transponder in order to
check signal strength and quality of reception. Transponder list contains predefined
transponders. If you need to modify transponder list please use menu Edit satellites as
described in chapter 5.2.3. If you need to scan specific transponder then use Manual
scan as described in this chapter below.