Operation Manual
PART 1 • English
16
Network search: if this item is set to “No” then receiver will search for the channels that are available from
preset transponder list of selected satellite. If this item is set to “Yes” then receiver in
addition will search for the channels from transponders information about that can be
found from broadcast. Use this option to get new channels that appeared on satellite.
Search for: you can select type of the channels that will be installed to your receiver. If selected
All channels then receiver will install Free-To-Air and Scrambled channels. If selected
Scrambled then receiver will install only Scrambled channels. If selected FTA then
receiver will install only Free-To-Air channels. Once you complete all settings you can
start channel search process.
Press RED button to install channels from all transponders of the satellite;
Press GREEN button to install channels from transponder selected in Transponder item;
Press YELLOW button to enter to Manual setup channels from specific transponder or
to setup single channel with known Video and Audio PID.
Manual setup of channels
In Manual channel search menu you can setup all channels from specific transponder or single channel.
To setup all channels from specific transponder:
Satellite: indicate name of the satellite where channels will be searched
Frequency:
Use 0 ~ 9 buttons to enter frequency of transponder
Polarisation control: Use tu buttons to select polarisation of transponder
Symbol rate:
Use 0 ~ 9 buttons to enter symbol rate value
Network search: Use tu buttons to select ON or OFF
Search for: Use tu buttons to select type of channels to be installed Press RED (Search)
button to start channel search.
5.2.1.1 Positioner setup
If in Dish setup menu you have configured Dish mode as “DiSEqC 1.2” then you have to setup position of
the dish to each satellite that you want to install.
In Channel setup menu move menu focus to Dish position item and press OK button on remote control.
Menu Positioner setup will appear on screen.
Satellite:
Displays the name of satellite position of antenna for which you setup
Transponder:
Use tu buttons to select reference transponder, receivable in your location, to
measure signal strength and quality
Movement speed:
Use tu buttons to select between Slow and Fast. Slow speed allows you to fine adjust
position of the dish (each press to direction button will turn dish to short angle). Fast
speed can be used to adjust dish position roughly. If Movement speed set to Fast
press to direction button will cause continuous movement of the dish to appropriated
direction, to stop dish you will have to press OK button.
Move:
Use tu buttons to move dish to the East/West direction
Centre position: If you press
OK button while menu focus is on this item then dish will be turned to
centre position, which corresponds to true South direction.
Limits:
Use tu buttons to Enable or Disable software limits of your positioner.
Set limit: Use tu buttons to select East or West limit of dish movement range.