Operation Manual
PART 1 • English
17
English
Step by step recommendations of position setup
n Select reference transponder in order to check signal strength and quality during position setup.
n If you do not know current direction of your dish then move menu focus to Centre position
item and press OK. Dish will be turned to true South. Knowing your location longitude you
may understand direction where necessary to move dish in order to reach position of selected
satellite. For example: your longitude is 5° East and you want to setup dish position for ASTRA
1C, 1E (19° East). Then, from centre position, you need to move dish to East direction by
pressing to t button. If your longitude is 25° East then, in order to setup dish position for
ASTRA 1C, 1E (19° East), you need to move dish in West direction (from centre position) by
pressing to u button.
n To setup roughly position of the dish set Movement speed to Fast. Then move menu focus
to Move item of the menu and by short presses to t or u buttons move dish to necessary
direction. Check signal strength and quality indicators. Once levels start increasing – press OK
button to stop the dish. Set Movement speed to Slow and keep adjusting dish position until get
best possible values.
n Once you are sure that dish is fine adjusted press YELLOW (Store) or BLUE (Store & Exit)
button. Dish position for selected satellite will be stored.
NOTE: in order to avoid mechanical damage of your dish please, make sure those mechanical
limits in your motor are set correctly and dish would not hit any objects on its movement.
5.2.2 Dish set-up
In this menu you can setup parameters of your dish(es).
Dish number: Use tu buttons to select number of the dish. This number used in Channel setup
menu to create a link between satellite and corresponded dish configuration
LNB type: Use tu buttons to select type of LNB. If you set type to Universal then you
should enter values of Local Oscillator Frequencies in LO frequencies menu item
LO frequencies: this menu item selectable only in case LNB type is Universal. Press OK button
and using 0 ~ 9 buttons enter values in appeared dialog box.
Band control:
Use tu buttons to select value. Set to Auto in order receiver automatically
select Band by sending 22 kHz control signal. Set to ON in order receiver
generate 22 kHz control signal continuously, or set to
OFF in order to disable
22 kHz control signal.
Polarisation control: Use tu buttons to select value. Set to Auto in order receiver automatically
control polarisation. Set to 13 V or 18 V in order receiver supply LNB with
selected power, or set to
OFF in order to disable LNB power.
Switch type:
if you use DiSEqC switch the select appropriated type.
Switch input: select input number to which LNB is connected.
Dish mode: Use tu buttons to select between Fixed, DiSEqC 1.2 and GOTO X.