Operation Manual

PART 1 • English
19
English
Power On Channel
Use tu to select an item. If your choice is Fixed channel: press OK button to display a channel list,
select a channel and confirm selection with
OK button. Your receiver will always start with defined
channel. If your choice is Last Viewed then receiver will awake with the last watched channel.
S/PDIF
Use tu buttons to select Digital audio mode. PCM – the receiver will downmix AC3 audio to PCM
stereo. Dolby – the receiver will by-pass AC3 audio for future decoding by Digital Audio Amplifier.
5.3.2 TV Setting
In this menu, you can configure the TV setting such as HD type, TV type, Aspect Ratio, Screen Control,
RGB/YUV, Brightness, Contrast, Saturation.
HD type
Use tu buttons to select an item. Or press OK button to display a list of options, use pq buttons to
select a video output resolution and press OK button to confirm selection.
TIP: HD type is not selectable if output mode (YUV/RGB) set to RGB.
TV Type
Use tu buttons to select an item. Or press OK button to display a list of options, use pq buttons to
select TV Type and press
OK button to confirm selection.
TIP: if you have changed TV type and Video on screen not appears in 15 seconds – press
EXIT button 2 times. Such a problem can appear if your TV do not supports video in
NTSC format.
Aspect Ratio
Set accordingly to aspect ratio of your TV.
Use tu buttons to select an item. Or press OK button to display a list of options, use pq buttons to
select Aspect Ratio and press OK button to confirm selection.
Screen Control
Use tu buttons to select an item. Or press OK button to display a list of options, use pq buttons to
select Aspect Conversion and press
OK button to confirm selection.
RGB/YUV
Selects a mode of video output signal.
If you have connected your TV to receiver only by SCART cable then it is recommended to set RGB mode. If
you have connected your TV to receiver by HDMI or Component cable then this value must be set to YUV.
Use tu buttons to select an item. Or press OK button to display a list of options, use pq buttons to
select YUV or RGB mode and press OK button to confirm selection.