Operation Manual

PART 1 • English

English

1 = Set marker point in play back, press again to delete marker point.

2 = Jump to next marker point.

3 = Jump forwards in time. (See details in 7.6.5 DVR Conﬁguration under Step to)

Note: You can also access the Record Manager from viewing mode with the RED

key on the remote control. The help banner at the bottom of the screen

explains all buttons used in this record manager to edit. Press EXIT to save

the settings and quit the menu.

7.6.3 DVR HDD Information

This option shows relevant information about the connected USB device.

Select DVR HDD Information from the Media+ menu and press OK to enter.

Press EXIT to leave.

7.6.4 HDD Format

The HDD format menu allows you to format the connected USB device.

WARNING! Formatting will permanently delete ALL data stored on the connected device.

Please make a backup copy of all data you wish to keep before entering the

HDD Format menu. STRONG cannot be held responsible for loss of data

from USB devices used with this receiver.

Select HDD Format from the Media+ menu and press OK to enter. Use tu to select the partition you

wish to format (Partition 1 is set per default) and press q to highlight Format. Press OK to proceed,

select FAT or Cancel, or press EXIT to leave without formatting.

NOTE It is possible to use already NTFS formatted USB disks.

7.6.5 DVR Conﬁguration

This menu allows you to make settings for Time Shift, recording and playback.

Select DVR Conﬁguration from the Media+ menu and press OK to enter.

Use pq to move the highlight and tu to change settings.

Press EXIT to quit.

Time Shift: On or Off. When Time Shift is set to Off, Time Shift becomes inactive.

Time Shift to Record: On or Off. When set to On, Time Shift is also possible during record.

Record Type: TS or PS. When TS is selected, recordings will also include subtitles and

teletext (when available). PS makes recordings without these extras.

Record Selection Select the partition whereto the receiver should record.

Standby after record: On or Off. Select if receiver must go to standby mode after Timer record.

Step to: 30 sec to 10 min. Set the time step you like to jump forward with the button 3

during playback of recorded ﬁles.