User manual

13
PART 1 • English
English
Connection: Use this option to select the connection to your TV set. Select HDMI or TV
SCART. If connection type HDMI is selected, then only the CVBS signal is
available on the TV SCART.
Digital Audio Output: Toggles between PCM and Bitstream output. When PCM is selected, all
all digital audio will be converted to stereo audio. Bitstream enables multi-
channel audio on HDMI for use with a Home Cinema Set.
7.3.3 Local Time Setting
Here you can set up your region and time zone.
Region: Use tu to select the region you live in.
GMT Usage: Set to On for broadcaster defined time or to Off to input time and
date manually.
GMT Offset: Allows you to adjust the time zone you live in. This option is only available
when GMT Usage is set to On.
The GMT Offset range is "-11:30 ~ +12:00", increasing by half hours
progressively. The cities matching the set GMT Offset are displayed at the
bottom of the screen.
Summer Time: Select Off or On to add one hour extra for summer time during the summer.
Date: Date and Time settings are available only when GMT Usage is set to Off. Use
the 0~9 buttons to enter the date. Press EXIT to proceed.
Time: Date and Time settings are available only when GMT Usage is set to Off. Use
the 0~9 buttons to enter the time. Press EXIT to proceed.
Time Display: Select On to display time on screen, Off to remove.
7.3.4 Timer Setting
This menu allows you to set up to 8 timed events for recording or waking up the receiver.
Use pq to select Timer Setting from the System Setup menu and press OK to enter.
The receiver will display a list with 8 timers, followed by their respective status. Select the timer you
wish to set or change with pq and press OK to proceed.
The timer setup menu will now be displayed.
The following settings are available:
Timer Mode: Choose between Off (Timer inactive), Once or Daily (Timer will be executed
every day, same time) or Weekly (timer will be executed every week, same day,
same time)
Timer Service: Choose between Channel (Timer will wake up the receiver) or Record (Timer
will start to record the scheduled event).
Wakeup Channel: Use tu to select the channel the timer will wake up with.
Wakeup Date: Use the 0~9 buttons to input the date for the timed event.
Wakeup Time: Use the 0~9 buttons to input the start time.
Duration: Use the 0~9 buttons to input the timer duration.
When all settings are according to your wishes, use pq to move the highlight to Save and press OK
to confirm. To quit the timer without saving your settings, move the highlight to Cancel.