User manual

PART 1 • English

English

7.4.2 Load Factory Setting

This option allows you to reset the receiver to factory settings, which clears all stored channels.

WARNING! By resetting your receiver to factory default, all your settings and stored

channels will be permanently deleted. It will restore your receiver to an “out of

the box” state. Please use this option with care.

Use pq to select "Load Factory Setting" in the Tools menu and press OK. You are asked to

input password.

Input the correct password using the 0~9 buttons (default: 0000). A conﬁrmation window

is displayed.

Select Yes to return to factory settings. Select No to cancel.

Press EXIT to leave.

7.4.3 S/W Upgrade by OTA

This receiver is equipped with an Over The Air software upgrade option. An Over The Air update

might not be available in your region. Please visit our website www.strong.tv or contact your local

service hotline for more information about this option.

7.4.4 Upgrade by USB

This feature allows you to upgrade receiver software via the USB port. When new software is available

for your receiver, it can be downloaded from our website www.strong.tv.Place the software ﬁle

(unzipped) in the root directory of your USB storage device (HDD, memory stick etc.) and insert this

device into the USB port of the receiver.

Select Upgrade by USB from the Tools menu and press OK to proceed.

The upgrade menu will now be displayed.

Use pq to select Upgrade Mode and choose option Allcode.

Use pq to select Upgrade File and choose the ﬁle containing the new software.

Once all settings are made, move the highlight to Start and press OK to start the upgrade process.

After a few seconds, the receiver asks: “Are you sure to burn ﬂash?”. Select Yes to ﬁnalize the upgrade

or No to quit without upgrading.

NOTE If, after a software upgrade, the receiver should behave in an unexpected way,

please perform a factory reset as well. See chapter 7.4.2

WARNING! After an update the receiver restarts automatically. During the upgrade

process NEVER disconnect the receiver from the mains or switch off the

power! Doing so might damage your receiver and will void warranty!

7.4.5 Remove USB device safely

Select Remove USB device safely from the tools menu and press OK. The receiver will display a

message indicating that you can safely remove your storage device from the receiver.