Operation Manual

2.0 INTRODUCTION

2.1 Front Panel

1. Power ON/STAND BY

2. pq Chanel up/down

3. Display

I In ON mode channel number is shown

2.2 Rear Panel

1. ANT IN

To connect your terrestrial antenna

2. TO TV

If you want your antenna signals from “ANT IN” connector inject to second receiver or TV

set. Use this loop trough output “TO TV” to connect these by using a coaxial cable.

3. HDMI

Use this connection to connect the receiver to your TV using HDMI cable.

4. S/PDIF Digital audio output

Use this coaxial output to connect your receiver to the input of your digital audio ampliﬁer.

5. AUDIO Right (Red RCA) and Left (White RCA)

These connectors give you the possibility to connect the audio signal to an external ampliﬁer

or to the audio input of your TV.

6. TV SCART Connector

Use this connector to connect your receiver with your TV set using a SCART cable.

7. Main power switch

2.3 Remote control

Remove the battery compartment cover and load two AAA (UM-4 or R03) batteries. Make sure that the

batteries have been inserted in the correct polarities matching to the symbols +, - marked in the battery

compartment. Close the battery compartment cover. If replacing of batteries is necessary, replace both