Operation Manual

English

PART 1

4.0 CONNECTING THE ANTENNA

Preparations

1. Check if the broadcast in your country is horizontally or vertically polarised.

2. Fix the antenna to the multi-directional base as shown in the pictures:

3. Depending on how the signals are broadcasted (horizontally or vertically) you will have to

mount your antenna in the horizontal or vertical position for best performance.

4. Your antenna needs 5 V power to work properly. Check in the menu or user manual of your

terrestrial receiver to see if it supports the needed 5 V power.

Fig. 2 Fig. 3

 V: (Vertical-Broadcast) antenna mounted

 H: (Horizontal-Broadcast) antenna mounted

4.1 To power the antenna with Digital Terrestrial Receiver:

1. Turn on your TV set and turn on your Digital Terrestrial Receiver.

2. Press the “MENU” button on the remote control of your Digital Terrestrial Receiver. Check in

the Set-Up or Installation menu of your receiver to see if the antenna power is set to “ON”.

(Normally this is indicated in the menu as ANT power, Ext Antenna power or Active antenna

power.) Refer to the user manual of your Digital Terrestrial Receiver.

3. Once you are sure that your receiver supports 5 V antenna power, switch o your receiver

and disconnect it from the 230 V main power.

4. Take the supplied “long” coaxial cable and connect the end with the “F connector” (screw

type connector) to the antenna. Carefully press the inner lead of the cable into the Female-F

connector at the back of the antenna. Turn the covering nut clockwise with your HANDS

until it is xed.

5. Connect the IEC Male end to your receiver. Normally the input connector on your receiver is

marked as “ANT” (in) or as “RF” (in). Refer to the user manual of your Digital Terrestrial Receiver.

6. Connect your receiver to the 230 V main power and switch ON your receiver and TV set.

7. Proceed to 5.0 “Antenna installation”.