Operation Manual

14
A.1 Trouble shooting
In some region, the digital terrestrial signal may be weak. So you'd better use the antenna in
which the booster was built, for watching the weak signal channels.
Problem Possible cause What to do
Standby light not lit
Mains lead unplugged
Mains fuse blown
Check mains lead
Check fuse
No signal found
Terrestrial is disconnected
Terrestrial is damaged/misaligned
Out of digital signal area
Check terrestrial lead
Check terrestrial
Check with dealer
Scrambled channel
message
Channel is scrambled Select alternative channel
No response
to remote control
Receiver off
Handset not aimed correctly
Front panel obstructed
Hand set batteries exhausted
Plug in and turn on plug
Aim handset at front panel
Check for obstructions
Replace handset batteries
Forgotten channel lock
code
Look at your notice below.
If you didn’t notice it, please
contact help line
The remote control will
not operate your
receiver
(1) The batteries in your remote
control need replacing
(2) There is an obstruction
blocking the signal path between
the remote control and the box.
(1) Replace the batteries
(2) Check that there is
nothing in the way of the path
between the remote
control and the receiver
After moving the
receiver to another
room you find you are
no longer able to
receive digital
reception
The terrestrial feed former new
point may come through a
distribution system which may
reduce the digital signal now
received by the box.
Try a direct feed from the
antenna
A.2 Default PIN-Code
The default Pin code is 0000
If you change it, please note the new Pin Code here:
…………………………………………