Operation Manual

PART 1 • English
10
OK, the program name dialog will shown as below.
Use the LEFT/RIGHT buttons to move the cursor to the character you wish to edit. Use the UP/
DOWN buttons to change character (scroll alphabet). If you wish to delete character you have to
replace it with “space” character. When editing is complete, press the
OK button.
Move channel
Press the UP/DOWN keys to point the focus of the menu to the channel of your selection. Press
the LEFT/RIGHT keys to point the focus of the menu to the column “Move”. When the focus is on
column “Move”, press the OK button to confirm selection of the channel, using the UP/DOWN
buttons move the channel to its new location and press the OK button to confirm the new location.
Repeat this for every channel that you want to move.
Delete channel
Press the UP/DOWN keys to point the focus of the menu to the channel of your selection. Press the
LEFT/RIGHT keys to point the focus of the menu to the column “Del”. When the focus is on column
“Del”, press the OK button to mark the channel as selected to be deleted from the list. To apply the
changes press the EXIT button and confirm the channel’s deletion.
Delete All channels
To delete all channels from current satellite press BLUE button (Dell All). You will be asked to confirm operation.
5.1.2 Favourites Manager
Press the UP/DOWN keys to select the channel. Press the LEFT/RIGHT keys to point the focus to
the favourite group. Press the OK button to add the selected channel to the Favourite group. To
remove the channel from the favourite group, repeat same operation.
5.2 Installation
The installation menu contains three sub-menus; “Antenna Installation”, “Auto Scan” and
“Manual Scan”.
5.2.1 Antenna Installation
You can add a satellite, edit a satellite and delete a satellite in this menu.
Add satellite
If you want add a new satellite, press the RED key in this menu, a satellite list will appear on the
screen. Press RIGHT/LEFT to select the satellite. If the satellite does not exist in the satellite
list, please select “NEW SAT1”. After selection of a satellite from the satellite list, the Configure
Antenna menu will appear, please set the LNB Type, LNB Low Freq, LNB High Freq, Band control,
Polarisation control, DiSEqC Switch and Antenna mode. Further steps of installation are described
in 4.2.
Edit satellite
If the parameters of the satellite were changed or the satellite is a new satellite, you must set the
parameters of the satellite, such as LNB type, LNB low Freq, LNB High Freq, Transponder, LNB
Power, 22k Tone, DiSEqC and Antenna Mode. Sequence of editing of satellite parameters is same as
sequence of “Add satellite” described in 4.2