Operation Manual

PART 1 • English

English

5.3.3.1 Channel Lock

Set the system Channel Lock to ON or OFF. If the channel lock is on, the user has to enter the

parental PIN code correctly before watching the locked channel.

5.3.3.2 Menu Lock

Press OK to select whether you need the lock or not for the Menu, YES or NO, press OK to conﬁrm.

If the menu lock is on, then for some operations such as search program and set factory default,

you need to enter your PIN.

5.3.3.3 Parental Setting

Set some channels to lock status. If a channel is locked, the user has to enter the parental PIN code

correctly before watching the locked channel. Use the UP/DOWN keys to select the channel you

want to lock. Press the OK button to lock the channel.

5.3.3.4 Change PIN

Modifying the PIN, you must enter the 4 digits PIN and conﬁrm it again; the system PIN will be

changed to the new PIN.

5.3.4 System info

The system information displays information about your receiver such as software and User

Interface version. Compare version of the software given on this menu with version available in the

internet in order to know if you have latest version of software.

5.3.5 System Update

In this menu, you can select between “STB to STB” and “OAD”

5.3.5.1 STB to STB spftware transfer

1. First power off both STBs, connect them with cross RS-232.

2. Then power on master STB (master is STB from which you will copy software) and keep

slave STB off. Navigate in the menu of master STB and select

“System Update – STB to STB”.

3. When the status displays “detecting slave STB”, power on slave STB, after the master

STB detects the slave, the master starts transmission and burns.

4. While transmitting and burning, it is very important to avoid other operations such as

power off because this may cause destruction of the data in the FLASH memory and the

receiver will need to be repaired.

5. When update is complete, ﬁrst power off both STBs, then disconnect the RS-232 line.

5.3.5.2 Over Air Download (OAD)

Select this option in order to update your receiver with the latest software version. Software update

service is available from satellites Astra 1C, 1E, 1F at 19E and Hotbird 1, 2, 3, 4 at 13E.

If your antenna is primed to Astra 1C, 1E, 1F at 19E then enter following parameters:

Frequency: 12603; Polarity: H (Horizontal); Symbol rate: 22000