Operation Manual

10 www.strongsat.com
Installation
Connecting to the telephone line
Note
If your telephone wall socket is not an RJ11 socket (shown right), you will need
to use one of the supplied adapters. If your telephone wall socket is an RJ11
socket, you may need a splitter (not supplied) so that you can plug in both your
set-top box and your telephone.
1. Insert one end of the supplied telephone lead into the telephone socket
(labelled ) on the rear panel of your set-top box.
2. Choose the correct adapter for your location. If you are not sure which one to
use, compare with your telephone connector.
Insert the free end of your supplied telephone lead into the RJ11 socket on the
adapter.
3. Remove your telephone connector from your telephone wall socket. Insert your
telephone connector into the correct socket on your adapter.
Insert the adapter into your telephone wall socket.
Inserting your smart card
1. Take your smart card from its packaging (if you have not already done so). Make
sure that the picture is facing upwards, and that the gold chip (underneath) is
nearest to the slot when you insert your smart card.
2. Insert the smart card into the smart card slot of the front panel of your set-top
box. Insert it as far as it will go, without forcing it.
ir receive
message
online
Digital Satellite Receiver
6752
Taking care of your smart card
Do not remove and re-insert your smart card unnecessarily.
Do not bend your smart card; keep it away from children and pets.
Do not put your smart card in liquids or use cleaning fluids on it.
❖
❖
u
u
u