Operation Manual

14 www.strongsat.com
Installation
Setting the antenna configuration and choosing a satellite
When you select ‘Manual’, the Antenna Configuration screen appears.
1. Press
L or R to select the number of
LNBs you have in your set-up.
2.
Press D to highlight the ‘LNB Index’ line,
then press L or R to select LNB Index 1.
3. Press D to highlight the ‘Satellite’ line,
then:
u If you are using a single fixed LNB,
press L or R to select the satellite
that your LNB is set-up for. Then
press OK and continue to the
section ‘Checking the signal and searching for channels’.
u If you are using a DiSEqC™ unit*, select the satellite for the LNB connected
to port 1.
4. Press
U to highlight the ‘LNB Index’ line, then press R to select LNB Index 2.
5. Repeat steps 3 to 4 to select an LNB Index for each of the ports on your
DiSEqC™ unit. Then press
OK and continue to the section ‘Checking the signal
and searching for channels’.
Checking the signal and searching for channels
The Signal quality screen is now displayed. You use this screen to confirm that your
set-top box is receiving a satellite signal.
The details on the screen show the name
of the satellite, together with bars showing
the strength and quality of the signal being
received from this satellite.
Your set-top box must receive both a signal
strength and a signal quality of about 60% in
order to successfully find channels.
Follow the instructions for ‘Automatic set-up’
or ‘Manual set-up’ on page 15, depending on
which set-up you have chosen.
*DiSEqC™ is a trademark of Eutelsat.