Operation Manual

15
ENGLISH
www.strongsat.com
Automatic set-up
Your set-top box is preset in the factory with the correct LNB settings to receive
signals from up to two satellites.
1. Press
L or R to change which LNB index details are displayed.
2. Check that your set-top box is receiving an adequate signal according to the
table below.
If you have.... Check for adequate signal strength and
quality on...
A single, fixed, universal LNB Index 2, Sirius
Two, fixed, universal LNBs Index 2, Sirius
and Index 1, Thor
If there is no signal, check your installation. Check all the connections are properly
made. See also the section ‘Solving problems’ on page 34.
3. When you are satisfied that there is an adequate signal, press
OK.
The Viasat Automatic Scan screen appears.
4. To start the channel search, press
OK.
A progress screen displays to confirm that the search is taking place.
When the search is complete, a screen displays to tell you the number of TV and
radio channels that your set-top box has found.
5. To confirm these channels and display the next screen, press
OK. Then see
‘Activating your subscription’ on page 16.
Manual set-up
1. Press
L or R to change which LNB index details are displayed.
2. Check that your set-top box is receiving an adequate signal on the satellites that
you selected for each LNB index.
If there is no signal, check your installation. Check all the connections are properly
made. See also the section ‘Solving problems’ on page 34.
3. When you are satisfied that there is an adequate signal, press
OK. The Manual
Scan screen appears.
The ‘Satellite’ line shows the satellite you
selected as LNB index 1, and the details below
show the search settings for that satellite.
If you have more that one LNB, you can view
the details for each satellite by highlighting the
‘Satellite’ line then pressing L or R.
Installation