Operation Manual

ENGLISH

www.strongsat.com

Setup

Using the Signal Settings menu

You use the Signal Settings menus to:

select the antenna and LNB conﬁguration that you have connected to your set-

top box;

select a Receiver Number, if the set-top box is used in a Satellite Channel

Router (SatCR) installation;

Note: It is important that, while you are conﬁguring a set-top box for a SatCR

installation, any other installed set-top boxes must be disconnected from the mains

power supply.

check that your set-top box is receiving satellite signals, and check the strength

and quality of the signal;

carry out a search for new channels.

To display the Signal Settings menu:

1. On the Setup menu, highlight ‘Signal

Settings’, then press OK.

2. If the set-top box you are conﬁguring

is used in a SatCR installation, highlight

‘SatCR LNB’ and press OK. The settings

menu (bottom right) appears.

Otherwise, highlight ‘Universal LNB’ and

press OK. The settings menu (bottom

left) appears.

3. Press

D or U to highlight the item you

want, and press OK. Then see the relevant section on the following pages.

4. When you have ﬁnished using the Signal Settings menu, press

back to redisplay

the Setup menu.

❖