Operation Manual

30 www.strongsat.com
Setup
Changing the antenna configuration
This is the number of LNBs available in your dish installation.
If you change your satellite dish installation, you may need to change this setting so
that your set-top box can tune to all the satellites available.
To change the Antenna Configuration:
1. On the settings menu, highlight ‘Antenna Configuration’, then press
OK.
The Antenna Configuration menu displays.
2. Highlight ‘Number of LNBs’, then press
L or R to select the number of LNBs
you have in your set-up.
3. Highlight ‘LNB index’, then press
L or
R to select the LNB index you want to
change. If you are using a single fixed
LNB, this will be LNB index 1.
4. Highlight ‘Satellite’ then select the
satellite that you want that LNB to
direct towards.
If you are using a single fixed LNB, press L or R to select the satellite that
your LNB is set-up for. Then go to step 6.
If you are using a DiSEqC™ unit*, select the correct satellite for the LNB
connected to each port. LNB Index 1 is associated with port 1, and so on.
5. Repeat steps 3 and 4 to select an LNB index for each of the ports on your
DiSEqC™ unit.
6. To save the changes, press
OK.
7. If you have changed your antenna configuration, you must then check the signal
quality and search for the new channels (see page 31).
Changing the Receiver Number (for SatCR installations)
This is the number (1 to 4) that will be allocated to your set-top box. It is important
that each set-top box in a SatCR installation has a unique number, to avoid conflicting
with other installed set-top boxes.
To change the Receiver Number:
1. On the SatCR LNB menu, highlight
‘Receiver Number Allocation’, then
press OK.
2. Press
L or R to select the Receiver
Number you want.
3. To save the changes, press
OK.
u
u
*DiSEqC™ is a trademark of Eutelsat.