Operation Manual

6 www.strongsat.com
Installation
To install your Strong set-top box, follow the
instructions from this page up to page 14.
The supplied equipment
If you have not already done so, remove all the
packaging.
You should have the following items:
Strong set-top box (see page 5)
Remote control and batteries (see pages 3 and 4)
User guide
Mains lead - with 2-way set-top box connector
and 2-pin mains plug (see right)
SCART lead (see right)
RF lead (see right)
Telephone lead - RJ11 to RJ11 (see right)
Telephone line (RJ11) adapter suitable for your
location (see page 10)
Where to place your set-top box
Before you start, make sure that your TV, VCR and set-
top box will be placed in a location that is conveniently
located:
near an easily-accessible mains wall socket;
within reach of your TV-antenna and satellite-dish
leads;
within 10 metres of a telephone point. (If not, you
will need an extension telephone lead.)
WARNING
Before you connect your set-top box to any other
equipment, you must disconnect ALL the equipment
from the mains supply.
❖
u
u
u
u
u
u
u
u
❖
u
u
u
Mains lead
SCART lead
RF lead
Telephone lead