Instructions / Assembly

ManualsBrandsSTRONGAR ManualsDoor Knobs & HardwareLadder Style 16 in. x 1 in. Back-to-Back Polished Chrome Stainless Steel Door Pull Handle

Back to Back Installation

1. Drill holes at required center to center locations using the

drill size required by bolt size (Every handle varies, 3/8” to 1/2” diameter)

2. Insert the bolt through the push side of

the door to the pull side.

3. Tighten the outside pull with the bolts. Make sure

the pull is properly tightened and snug to the door face. The

bolts should be rigid before proceeding.

4. Slide the inside pull over the bolt and hold the inside

pull tight to the face of the door while tightening the set

screws.

Note : It is imperative that the set screws are rmly tightened

and that the door pull is tight against the door face so that the

set screw properly engages the head of screw.

DOOR | NYLON WASHER | NYLON SPACER| ESCUTCHEON | OUTSIDE PULL

Center to Center - Chart

Handle Size Center to Center

For Installation Assistance, Call 800-259-7254 • www.strongarhardware.com

Installations Instructions

Back to Back

(Glass, Wood or Metal)

Inside Pull

Set Screw

Bolts

Escutcheon

Outside Pull

Ladder Pull Handles

12 inches

16 inches

18 inches

24 inches

32 inches

36 inches

48 inches

60 inches

72 inches

6 inches

10 inches

12 inches

18 inches

26 inches

30 inches

42 inches

54 inches

66 inches

Nylon Spacer

Nylon Washer

Door

Collar

Center to Center