Installation Guide

1. Drill holes at required center to center location using the drill size required by bolt size (every handle

varies, 3/8” to 1/2” diamter)

2. Insert the bolt through the push side of the door to the pull side.

3. Tighten the outside pull with the bolts. Make sure the pull is properly tightened and snug to the door face. The bolts

should be rigid before proceeding.

4. Slide the inside pull over the bolt and hold the inside pull tight to the face of the door while tightening

the set screthe set screw.

Note: It is imperative that the set screws are firmly tightned and that the door pull is tight against the door

face so that the set screew properly engages the dead of screw.

*** “Escutcheon” does not apply for the Square Handles ***

CORRECT ORDER OF MOUNTING ACCESSORIES

DOOR | NYLON WASHER| NYLON SPACER | ESCUTCHEON | OUTSIDE PULL

Pull Handles

Ladder Style & 90º Style

Back-to-Back Installation

For Glass, Wood or Metal Doors