Product Manual

ManualsBrandsStrongArm Manuals3,000 - 4,900 Lb. Capacity WinchesDutton-Lainson 12 Volt DC Powered Electric Winch — 4,500-Lb. Capacity, Galvanized Aircraft Cable

ELECTRIC WINCH RATING*

5% 10% 20% 30% 50% 70%

(3°) (6°) (11°) (17°) (26°) (35°)

SA5000 10,000 lbs. 7,500 lbs. 5,100 lbs. 3,900 lbs. 2,700 lbs. 2,200 lbs. 1500 lbs.

4,536 kg 3,402 kg 2,313 kg 1,769 kg 1,225 kg 998 kg 680 kg

SA7000 14,600 lbs.11,000 lbs. 7,400 lbs. 5,700 lbs. 4,000 lbs. 3,300 lbs. 2200 lbs.

6,623 kg 4,990 kg 3,357 kg 2,586 kg 1,814 kg 1,497 kg 998 kg

SA9000 20,000 lbs.15,000 lbs. 10,200 lbs. 7,700 lbs. 5,500 lbs. 4,500 lbs. 3,000 lbs.

9,072 kg 6,804 kg 4,627 kg 3,493 kg 2,495 kg 2,041 kg 1,361 kg

SA12000 30,000 lbs. 22,600 lbs.15,200 lbs.11,600 lbs. 8,300 lbs. 6,800 lbs. 4,500 lbs.

13,608 kg 10,251 kg 6,895 kg 5,262 kg 3,765 kg 3,084 kg 2,041 kg

12 Volt DC

E LECTRIC WINCHES

WARNING: READ INSTRUCTIONS CAREFULLY BEFORE

ATTEMPTING TO INSTALL, OPERATE OR SERVICE THE STRONGARM

ELECTRIC WINCH. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT

IN SERIOUS OR FATAL INJURY. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.

DOUBLE LINE OPERATION

Models SA7000 and SA12000 are factory equipped

with a pulley block and hook and 50' of cable for

double line operation. This increases the pulling

capacity of the winch as shown, however, care

must be taken to allow adequate motor cooling.

Note that with double line, a pull of 25' requires

reeling in 50' of cable.

For intermittent use only. Ratings at left are based

on 10' pull. For longer pulls motor cooling periods

must be allowed.

MAXIMUM CONTINUOUS RUN TIME 4 MINUTES

CAUTION: CONTINUOUS RUNNING IN

EXCESS OF 4 MINUTES WILL DAMAGE WINCH

MOTOR.

GUIDE TO ROLLING LOAD CAPACITY**

Maximum weight in pounds and kilograms rolling load.

APPROXIMATE LOAD SPEED

(FT./MIN.)

MODEL PERCENT INCLINE

LOAD

CAPACITY

(*) Load capacity (dead weight) is a measure of actual maximum force to which the

winch system may be subjected.

(**) All capacities shown are with 15' of cable on the reel and 10% rolling friction factor.

For full reel of cable adjust capacities according to graph above. Note 5% incline is

one-half foot rise in ten feet.

WINCH RATINGS

OWNER’S

MANUAL

MODELS SA5000, SA7000

SA9000, SA12000

5000

4500

4000

3500

3000

2500

2000

1500

1000

500

DEAD WEIGHT CAPACITY (LBS.)*

LENGTH OF CABLE ON REEL (FT.)

10 20 30 40 50

SA9000 single line

SA12000 double line

SA7000 double line

SA5000 single line

WARNING: NOT TO BE

USED AS A HOIST FOR

LIFTING, SUPPORTING OR

TRANSPORTING PEOPLE OR

LOADS OVER AREAS WHERE

PEOPLE COULD BE PRESENT!

NO LOAD FULL LOAD

Full Empty Full Empty

Reel Reel Reel Reel

SA5000 33 12 84

SA7000 16 6 4.5 3.5

SA9000 11 542.5

SA12000 5 2.5 2 1.5

Summary of content (8 pages)

PAGE 1
2 Volt DC ELECTRIC WINCHES â OWNER’S MANUAL MODELS SA5000, SA7000 SA9000, SA12000 E N G L I S H DEAD WEIGHT CAPACITY (LBS.)* WARNING: READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE OR SERVICE THE STRONGARM ELECTRIC WINCH. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN SERIOUS OR FATAL INJURY. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
PAGE 2
IMPORTANT SAFETY INFORMATION WARNING: FAILURE TO READ AND FOLLOW INSTRUCTIONS BELOW COULD RESULT IN SERIOUS OR FATAL INJURY. WARNING: NOT TO BE USED AS A HOIST FOR LIFTING, SUPPORTING, OR TRANSPORTING PEOPLE OR LOADS OVER AREAS WHERE PEOPLE COULD BE PRESENT. E N G L I S H This winch is not designed for movement of human beings. Do not use for scaffolding, elevators, or any other application in which persons could be positioned on or under the load at any time. Do not use as an overhead hoist.
PAGE 3
MOUNTING INSTRUCTIONS 1. Feed positive lead (long) wire only through any convenient access hole inside the car trunk. It may be necessary to remove a knockout plug or rubber grommet from the trunk floor. It may also be necessary to remove the circuit breaker assembly from the positive wire in order to feed the wire under the car. 2. Pull the positive lead wire along the underside of the car into the engine compartment and up to the battery.
PAGE 4
secured on the trailer, it is advisable to relieve the tension on the winch cable to avoid damage to the winch and trailer due to high shock loads encountered when traveling. 5. Always disconnect the switch when the winching operation is complete. Never leave the switch connected to the winch when not in use. position when cranking in a clockwise direction to retrieve the cable.
PAGE 5
2. With the cover removed as described above, inspect the entire gear train and all drive shafts for any significant wear or loose bearing fits. Grease all of the gears on the inside of the winch base and apply a drop of oil on all of the bearings in the base. Also, very sparingly oil all of the bearings in the clutch mechanism and place a drop of oil on the roller clutch. Do not over lubricate these areas and do not use grease in the roller clutch.
PAGE 6
WIRING DIAGRAM E N G L I S H Ref. Part A B C D E F G H K N P Q R S T U V W X Y Z SA5000 and SA7000 PARTS LIST Number Retaining Ring (2) 205191 Bushing 204012 Drive Shaft Ass’y. 304813 Bushing 204009 56T Gear 204703 Handle Ass’y. 304412 Base Spacer 404557 Base 404922 Brake Spring Replacement Kit 5703186 Locknut, 7/16-20 205192 Clutch Stud 404517 Thrust Bearing Replacement Kit (Includes Item X) 5703194 Clutch Handle Replacement Kit (Includes Items W, X, AQ & AR) 5703178 Clutch Gear Ass’y.
PAGE 7
E N G L I S H WIRING DIAGRAM Ref. Part A B C D E F G J K L M N P Q R S T U V W X Y SA9000 and SA12000 PARTS LIST Bearing Housing Assy. Primary Drive Shaft Assy. Retaining Ring (2) Bushing (2) 56T Gear Aux. Handle Assy. Drive Shaft Bushing Housing Assy. Interm. Drive Shaft Assy.
PAGE 8
ELECTRIC WINCH SERVICE CENTERS FLORIDA Hagood Brothers Marine 1121 West Church St. Orlando, FL 32805 Tel: 407-843-4220 E N G L I S H NEBRASKA Dutton-Lainson Company 1601 West 2nd Hastings, NE 68902 Tel: 402-462-4141 INDIANA RG Shamory Enterprises 55625 Currant Road Mishawaka, IN 46545 Tel: 219-255-5050 OKLAHOMA Tow Dolly Enterprises 1520 S.