Product Manual

Page 9 of 16
5. See Figure 5. Place the assembled hose reel (E) onto the top of the frame (A). Ensure that the
water inlet (with the bearing bracket) is on the same end of the cart as the front axle (C). Place
the bearing bracket (F) onto the other end of the hose reel assembly (E) and secure using four
M6 x 42mm screw, nut and washers (K).
Figure 5
6. See Figure 6. Insert the crank handle (G) into the bearing at the rear of the frame (F). Align the
holes for proper placement and secure using one M6 x 30mmscrew, nut and washer set (J).
Figure 6