Product Manual

BEFORE USE

1. Before using this product, read the owner's manual completely and familiarize yourself thoroughly

with the product and the hazards associated with its improper use.

2. Perform the air purge procedure. (See previous instructions for system purge procedure.)

3. Pour a teaspoon of good quality, air tool lubricant into the air supply inlet of the lift control valve. (See

illustration) Connect to air supply and operate for 3 seconds to evenly distribute lubricant.

4. Check and that the pump operates smoothly before putting into service.

5. This product is fitting use standard 1/4" NPT air fitting. If changing the fitting is required, install a 1/4"

NPT fitting of your choice, ensure that thread tape or compound is used to seal connection.

6. Inspect before each use. Do not use if bent, broken or cracked components are noted.

OPERATION

RAISING THE JACK

Note: The jack is equipped with a handle position lock. To adjust the handle, release lock device by

pulling the lever up, lever is spring loaded and will lock into desired position. Ensure lever locking

mechanism is fully engaged before letting go of the handle.

1. Block the vehicle’s wheels for lifting stability. Secure the load to prevent inadvertent shifting and

movement

2. Position the jack near desired lift point.

3. Set the Parking Brake in the vehicle.