Product Manual

7
MAINTENANCE INSTRUCTIONS
Maintain your lift table. It is recommended that the general condition of any lift table be examined
before it is used. Keep your lift table in good repair by adopting a program of conscientious repair
and maintenance. Have necessary repairs made by qualified service personnel.
If you use and maintain your equipment properly, it will give you many years of service. Follow the
maintenance instructions carefully to keep your equipment in good working condition. Never perform
any maintenance on the equipment while it is under a load.
Visual inspection shall be made before each use of the lift by checking for abnormal conditions, such
as cracked welds, and damaged or missing parts.
Because of the potential hazard associated with the lift, no alterations shall be made to the products.
Inspection
You should inspect the product for damage, wear, broken or missing parts (e.g.: pins) and that all
components function before each use. Follow lubrication and storage instructions for optimum
product performance.
Binding
If the product binds while under a load, use equipment with equal or a larger load capacity to lower
the load safely to the ground. After un-binding; clean, lubricate and test that equipment is working
properly. Rusty components, dirt, or worn parts can be causes of binding Clean and lubricate the
equipment as indicated in the lubrication section. Test the equipment by lifting without a load. If the
binding continues contact Customer Service.
Cleaning
If the moving parts of the equipment are obstructed, use cleaning solvent or another good
degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.
Lubrication
This equipment will not operate safely without proper lubrication. Using the equipment without
proper lubrication will result in poor performance and damage to the equipment. Some parts in this
equipment are not self-lubricating inspect the equipment before use and lubricate when necessary.
After cleaning, lubricate the equipment using light penetrating oil, lubricating spray.
-Use a good lubricant on all moving parts.
-For light duty use lubrication once a month.
-For heavy and constant use lubrication recommended every week.
-NEVER USE SANDPAPER OR ABRASIVE MATERIAL ON THESE SURFACES!
Rust Prevention:
-Check threads and pivot point’s assemblies daily for any signs of rust or corrosion.
-Without a load lift the equipment as high as it goes and look under and behind the lifting points. If
signs of rust are visible clean as needed.
Grease Fittings
-Some models contain grease fittings the will regularly need to be greased and lubricated.
Storing the Lift
1. Lower the Lifting Saddle in the full down position.
2. Store in a dry location, recommended indoors.
3. Store the handle with care.
Note: If the lift is stored outdoors, be sure to lubricate all parts before and after use to ensure the lift
stays in good working condition.