30” COMMERCIAL PEDESTAL FAN Owner’s Manual WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
Thank you very much for choosing a Strongway product! For future reference, please complete the owner’s record below: Serial Number/Lot Date Code: ________________________________ Purchase Date: ____________________________________________ Save the receipt, warranty, and this manual. It is important that you read the entire manual to become familiar with this product before you begin using it. This fan is designed for certain applications only.
Table of Contents Intended Use ....................................................................................................................................... 4 Technical Specifications .................................................................................................................... 4 General Safety Rules.............................................................................. Error! Bookmark not defined. Important Safety Considerations .......................................
Intended Use High velocity cooling, ventilation, and circulation of commercial environments. Technical Specifications Property Voltage Specification 120V~ / 60Hz Watts 220 W Amps 2.1 A Read and understand all instructions. Failure to follow all instructions may result in serious injury. The warnings, cautions, and instructions in this manual cannot cover all possible conditions or situations that could occur. Exercise common sense and caution when using this tool.
Important Safety Considerations FAN USE AND CARE Do not modify the fan in any way. Unauthorized modification may impair the function and/or safety and could affect the life of the equipment. There are specific applications for which the fan was designed. Always check of damaged or worn out parts before using the fan. Broken parts will affect the fan operation. Replace or repair damaged or worn parts immediately. Store idle fan.
PERSONAL SAFETY Never insert fingers or any other objects into grill guard when fan is in operation. Disconnect the fan from its power source when moving from one location to another. Disconnect the fan from its power source when removing guards for cleaning. Be sure fan is placed on a secure, level surface. Does not use fan in windows. Rain and moisture may create electrical hazard. Close supervision is necessary when this fan is used near children, the elderly and pets.
FAN USE AND CARE Check for damaged parts before each use. Carefully check that the tool will operate properly and perform its intended function. Replace damaged or worn parts immediately. Never operate the tool with a damaged part. Do not use a tool with a malfunctioning switch. Any power tool that cannot be controlled with the power switch is dangerous and must be repaired by an authorized service representative before using. Unplug the power cord from the outlet..
1. Unscrew the set screws from the MOTOR. 2. Set the REAR GUARD in its proper position. Please make sure the REAR GUARD fits securely against the motor housing. 3. Attach the REAR GUARD by inserting and tightening the screws to the motor (through the eyelets on the guard). 4. Insert the BLADE on the motor shaft until it reaches a stopping point and the SET SCREW is in line with the flat groove on the SHAFT. NOTE: Be sure the set screw of the blade is facing the motor of the fan. 5.
CLEANING: WARNING: UNPLUG FROM ELECTRICAL SUPPLY BEFORE CLEANING. 1. Use a soft, damp cloth (water only) for cleaning, then wipe with dry cloth. 2. Don’t not use cleaners that harm paints or plastics; i.e., bleach or ammonia. 3. Do not bend blades Parts Diagram Parts List Part# 1 2 3 4 5 Description SCREWS COUPLING (ATTACHED TO OUTER TUBE) OUTER TUBE BASE NUT (TO ATTACH BASE TO OUTER TUBE) Qty. 6 Part# 12 Qty.
Troubleshooting Surges in electrical power or excessive heat may cause the fan to turn off. Wait approximately 15 minutes for the fan to resume operation Replacement Parts For replacement parts and technical questions, please call Customer Service at 1-800-222-5381. Not all product components are available for replacement. The illustrations provided are a convenient reference to the location and position of parts in the assembly sequence.
Distributed by Northern Tool and Equipment Company, Inc. Burnsville, Minnesota 55306 NorthernTool.
