Product Manual

Page 9 of 16
Adjusting the Control Handle- 3 Positions
On the Handle Tube (1) of this pallet jack, you can find the Control Lever (5), which can be placed in
three positions (See Fig. 3):
LOWER - To lower the load, pull up on the control lever.
NEUTRAL - Place the control lever in this position while pulling the pallet jack or load.
LIFT - To raise the load, push down on the control lever and pump the handle to raise the load.
Fig. 3
Note: These three positions have been set at the factory to work appropriately as soon as the
handle tube is attached. Check to see if the pallet jack works well in the 3 control positions. If the
forks do not raise or lower as expected, proceed to the following steps (see Fig. 4):
1. Pull the Control Lever (5) upward to the "LOWER" position. If the fork frame does not lower,
turn the Nut (13) CLOCKWISE until the fork frame lowers.
2. Push the Control Lever (5) down to the "LIFT" position. If the fork frame does not elevate,
turn the Nut (13) COUNTER-CLOCKWISE until the fork frame elevates.
3. Keep the control handle in the "NEUTRAL" position. If the fork frame lowers, turn the Nut
(13) COUNTER-CLOCKWISE until the fork frame does not lower.
4. Check to see if the pallet jack works well in the 3 control positions. If not, repeat the steps
above until the pallet jack works well.
Fig. 4
Lower
Neutral
Lift