Product Manual

Page 9 of 17
1. When installing on a bench, place the sharpener on the edge of the bench to the stop (Fig. 1) and
screw it to the desk using the holes in the base.
2. When mounting on the wall, use the respective holes in the vertical part of the base.
3. After the bench top installation, fit the arm in the base, inserting the pilot pin and securing it with a
hexagonal screw (Fig.2).
4. Now, fit a washer (included) on the rear side screw and screw on the setting wheel (Fig.3).
5. Screw the hand piece onto the bolt in the grinding disc body (Fig.4).
6. Secure the grinding disc guard using the supplied screws and a wrench (Fig.5).