Product Manual

Page 12 of 18

2. Place the pulley hook assembly (69) (without the hook attached) onto the wire cable below the

line blocker. Make sure the pulley hook roller is aligned on the wire cable (19) and is not in any

way askew or oblongly seated on the wire.

3. Slide the bolt (71 and 72) back into the pulley (69), hook, and all of the washers (80 and 81).

Finally, tighten the nuts (75 and 76). See the illustration above.

Emergency Stop Switch

If an emergency occurs, press the emergency stop switch (83) immediately.

After Each Use

⚠WARNING

 DO NOT store the wire rope where it can be of any harm.

 Place the electric wire rope in a dry and clean place for future use.

 Lubricate the rope occasionally with light oil. Check that it is in good condition.