Product Manual

Page 12 of 17
The unit will switch automatically from Charging to Maintain mode when the battery is fully charged.
Aborted Charge
If charging cannot be completed normally, the unit will abort the procedure and an error message will
appear. (Check the Error Codes in the trouble shooting section.) To reset an aborted charge, unplug
the charger/maintainer from the outlet, check connections and fuse, wait a few minutes, and plug it
back in.
Desulfation
If the battery is left discharged for an extended period, the battery could become sulfated. A sulfated
battery will not accept a normal charge.
⚠WARNING
 Select only one charging method at one time.
3A Charge Rate
This charger is recommended for charging small batteries such as those used in motorcycles, ATVs,
snowmobiles, personal watercraft, lawn tractors, and golf cars. It is also suitable to maintain larger
batteries such as those used in automobile, marine and farm tractors.
LED Indicator
 A green LED indicates that a 6V battery is being charged.
 A green LED indicates that a12V battery is being charged.
 A red LED indicates that an error occurs.
DIGITAL DISPLAY
6V Battery
1. Displays "LO" when battery capacity is less than 60%.
2. Displays "60%-70%-80%-90%" when battery voltage goes up gradually.
3. Displays “FUL" when charger goes into float charge mode.
4. Displays Error codes when abnormal conditions occur.
12V Battery
1. Displays "LO" when battery capacity less than 60%.
2. Displays "60%-70%-80%-90%" when battery voltage goes up gradually.
3. Displays “FUL" when charger goes into float charge mode.
4. Displays Error codes when abnormal conditions occur.
Connection Methods
This charger comes with 2 run connect charging leads for extra versatility – standard clamps and ring
terminals. The battery may be charged using any of the two connection options.
⚠WARNING
 Select only one charging method at one time.