Product Manual

3E
SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND CLIP
The wand can be attached
to the metal frame using the
wand clips.
Wand Clip
O-ring
Wand
Retaining Nut
Shut-off
Valve
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
The top of the shoulder straps are attached to the tank.
Attach the lower end of the straps by clipping the strap hooks to the
metal frame between where the frame exits the tank and curves around.
INSTALLING THE SHOULDER STRAP
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft (A)
aligning the pump handle hole and shaft hole. Slide the bolt (B) through
the aligned hole as shown in figure 1 thru 4. Tighten nut (D) to bolt.
There are holes in the pump handle to allow for either left(fig.4) or right
(fig.5) hand mounting.
Figure 1 Figure 2
Line up holes
Figure 3
Slide bolt through holes
Figure 5
Left Hand
Figure 6
Right Hand
Figure 4
Tighten nut to bolt
Threaded Bolt
Nylon Lock Nut
A. Pump Shaft
B. Bolt
C. Pump Handle
D. Nut