Single COB LED Solar-Powered Motion Security Light Owner’s Manual WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
Thank you very much for choosing an Ironton™ product! For future reference, please complete the owner’s record below: Serial Number/Lot Date Code: ________________________________ Purchase Date: ____________________________________________ Save the receipt, warranty, and this manual. It is important that you read the entire manual to become familiar with this product before you begin using it. This solar-powered light is designed for certain applications only.
Table of Contents Intended Use .......................................................................................................................................... 4 Technical Specifications ...................................................................................................................... 4 Important Safety Information ............................................................................................................... 4 Assembly Instructions .............................
Intended Use The Ironton Single COB LED Solar-Powered Motion Security Light delivers brilliant illumination and the convenience of motion activation. Installation is easy with no wiring required, allowing you to place this weather-proof light anywhere. Motion detected within a 40 foot range automatically triggers the light. The amorphous solar panel charges the rechargeable battery even in low light conditions.
handle the solar powered light. Be aware of all power lines, electrical circuits, water pipes, and other mechanical hazards in your work area. Some of these hazards may be hidden from your view and may cause personal injury and/or property damage if contacted. ⚠WARNING PERSONAL SAFETY Stay alert, watch what you are doing, and use common sense when operating the tool. Do not use the tool while you are tired or under the influence of drugs, alcohol, or medication.
• Adjust the motion sensor to your desired position. Your light is now installed and ready to charge. Note: The lamp unit should be mounted 6.5 ~ 9.8 feet from the ground to ensure motion detection is optimized. 2. Solar Panel Wall or Roof Mounted Installation • Choose an area that receives the maximum amount of sunlight possible. • Use the holes located on the solar panel mounting bracket to mark the mounting surface for installation.
The TIME dial sets the duration the light will stay on when triggered. The duration is adjustable from 5 seconds to 2 minutes. Rotating the dial clockwise will increase the duration the light will stay on. SENS (Sensitivity) The SENS dial adjusts the sensitivity of motion detection: 1. 2. 3. Minimum position – Low Range: large movement is required to trigger the light to turn on. Mid Position - Medium setting. Maximum position - Maximum range: the smaller movements will trigger the light to turn on.
Troubleshooting Use the following table to troubleshoot problems before contacting service personnel or your local dealer. If the problem continues after troubleshooting, call your local dealer for assistance. Failure Possible Cause Corrective Action Ensure the solar panel is in a location where it will receive maximum sunlight during daytime hours. Batteries are not charged. Turn the light to the OFF position and allow the solar panel to charge the batteries for two sunny days.
Failure Possible Cause Corrective Action Turn the light to the OFF position and allow the solar panel to charge the batteries for two sunny days Solar panel is not receiving enough sunlight and not able to recharge batteries. Clean the solar panel with a clean damp cloth.
Replacement Parts For replacement parts and technical questions, please call Customer Service at 1-800-222-5381. Not all product components are available for replacement. The illustrations provided are a convenient reference to the location and position of parts in the assembly sequence. When ordering parts, the following information will be required: item description, item model number, item serial number/item lot date code, and the replacement part reference number.
Limited Warranty Northern Tool and Equipment Company, Inc. ("We'' or "Us'') warrants to the original purchaser only ("You'' or “Your”) that the Ironton product purchased will be free from material defects in both materials and workmanship, normal wear and tear excepted, for a period of one year from date of purchase. The foregoing warranty is valid only if the installation and use of the product is strictly in accordance with product instructions.
Distributed by: Northern Tool & Equipment Company, Inc. Burnsville, Minnesota 55306 www.northerntool.