User Manual

13
Rotary Handpiece Screen
This screen appears when a TPS rotary handpiece is selected. The TPS Universal
Drill is plugged into the TPS2 port and the speed is set at 75,000 RPM.
ENDO, TPS1 and the footswitch icons indicate that other instruments are plugged
into the console.
SPEED/WATER ADJUSTMENT
The speed icon functions as a toggle
switch for speed and water settings.
Speed and irrigation adjustments are
made using the adjustment arrows.
DIRECTION OPTIONS
FORWARD Clockwise
REVERSE Counterclockwise
OSCILLATE
TPS MicroDriver and Universal
Driver
METHOD OF OPERATION
The TPS MicroDriver can be operated with its built-
in trigger and rotary control switch or with the TPS
Footswitch.
NOTE: The handpiece will not run when the rotary
switch is in the SAFE position.
Trigger The built-in speed control trigger(s) runs
the handpiece from start-up to the maximum
selected speed.
MicroDriver only: Select cutting direction with the
rotary switch on the handpiece. Direction icon will
highlight to match the rotary switch position.
Universal Driver only: Select cutting direction by
depressing either the forward trigger or the reverse
trigger. Squeezing both triggers simultaneously
runs the handpiece in the oscillate mode. The
oscillate icon will become highlighted.
Footswitch Handpiece runs from start-up to the
maximum selected speed.
The direction icon on the screen changes when the
corresponding footswitch pedal is depressed.
Footswitch operation overrides handpiece settings.
Example: If the footswitch reverse pedal is de-
pressed while the handpiece rotary switch is set in
forward, the handpiece operates in the reverse
direction and the reverse icon highlights. However,
after the pedal is released, the direction icon will
revert to the direction set on the rotary switch.
TPS Universal and Micro Drills
METHOD OF OPERATION
The Universal Drill can be operated with the TPS Universal
Handswitch or TPS Footswitch.
Handswitch Handpiece selection can be made by depress-
ing the handswitch once. The handpiece select icon changes
to indicate the active handpiece. Depress the handswitch
again to run the handpiece.
Handpiece runs from start-up to the maximum selected
speed. Speed and cutting direction corresponds to what is
selected on the screen.
Footswitch Handpiece runs from start-up to the maximum
selected speed.
Handpiece direction is controlled by selecting the forward or
reverse pedals. The direction icon on the screen changes
when the corresponding footswitch pedal is depressed.