User Manual

21
Handpiece Button Mapping Screen
Access this screen from the Handpiece Adjustment
screen. Use it to change handpiece button func-
tions.
Depending on the features of the handpiece, as
many as five buttons can be reprogrammed. Identify
corresponding button numbers by pressing the buttons
on the handpiece. When the handpiece button is
selected, the corresponding function is displayed on the
screen. Use the arrow icons to scroll through the
function options. Stop on the desired option. See the
list below for a description of the options.
NOTE: Available options are handpiece specific.
BUTTON FUNCTIONS
Reset: Select to return a single button to its
default function.
Reset all: Select to return all buttons to their
default functions.
Return: Return to previous screen.
Button Function Description
Main trigger Starts handpiece in default direction
and mode.
FWD trigger Starts handpiece in forward
direction in default mode.
REV trigger Starts handpiece in reverse
direction in default mode.
OSC trigger Starts handpiece in oscillate mode.
Speed increment Increments the set point speed.
Speed decrement Decrements the set point speed.
Water increment Increments the pump flow set point.
Water decrement Decrements the pump flow set
point.
Water on/off Toggles the pump on/off button. If
pressed and held, the pump can be
turned on without running the
handpiece. Once started, the pump
can be stopped by pressing the
button again or by starting the
handpiece.
Button Function Description
Osc <> High/low Toggles the run mode between oscillate
and high or low.
High <> Low Toggles the run mode between high and
low.
Forward <> Reverse Toggles the running direction.
Change port Changes the active handpiece port.
Change attachment Scrolls through the attachment list for the
selected handpiece.
Pump flush Turns the pump on at the flush rate. Once
started the pump can be stopped by
pressing the button again or by starting
the handpiece.
Make port active Makes the selected handpiece active.
Button Functions List