User's Manual

15
DRAFT
To Adjust Handpiece Speed (or Power):
From the HOME screen, touch the plus and minus buttons to adjust the handpiece speed or power set point in rpms or
percentage of power.
NOTE: When you install a cutting accessory with cutter recognition capability, the system will automatically override
the selected speed setting in each mode to the speed settings that are appropriate for the installed cutting accessory.
To Select Handpiece Direction and Mode:
From the HOME screen, touch the Select Direction/Mode button to adjust the handpiece direction and mode.
The default speed is
displayed for each
handpiece until you
adjust the speed set
point based on the
handpiece capability.
Touch the adjustment buttons (or slider bar that
becomes visible when touching the speed value) to
increase or decrease the speed (power) set point.
While the handpiece is
running, the display
shows the actual
handpiece speed. If the
handpiece is not running,
the default or selected
speed is displayed.
Direction Options
Select the direction of
the cutting accessory
Mode Options
Select the mode of
handpiece
operation
REVERSE: Touch to cause the
handpiece cutting accessory to
rotate in the reverse
(counterclockwise) direction.
FORWARD: Touch to cause
the handpiece cutting
accessory to rotate in the
forward (clockwise) direction.
HIGH: Touch to cause the
handpiece to operate in
the high rpm range mode.
OSC: Touch to cause the
handpiece cutting
accessory to oscillate.
LOW: Touch to cause the
handpiece to operate in the
low rpm range mode.
NOTE: The available handpiece options,
including handpiece direction and mode, will
depend on the type of handpiece that is identified
at the top of the screen.