User's Manual

DRAFT

To Set Handpiece Options:

From the Adjust Options screen, touch the Set Handpiece Options button to select specific handpiece options and

assign them to a particular handpiece button. Options are handpiece dependent and may not be available if the

handpiece does not support them. Handpiece attachments may also be selected, if supported. If selected, the console

will display the correct attachment information and set maximum speed values for the handpiece.

Based on handpiece capabilities, options may include:

• FORWARD: option will rotate cutting accessory in the forward (clockwise) direction.

• REVERSE: option will rotate cutting accessory in the reverse (counterclockwise) direction.

• +OSC TURNS: option will increase the number of oscillate turns.

• -OSC TURNS: option will decrease the number of oscillate turns.

• HIGH: option will operate handpiece in the high-speed mode.

• LOW: option will operate handpiece in the low speed mode.

• CHANGE PORT: option will change the button assignment to another active handpiece.

• +IRRIGATION: option will increase irrigation to the handpiece cutting accessory.

• -IRRIGATION: option will decrease irrigation to the handpiece cutting accessory.

• WINDOW JOG TRIGGER: option will rotate the cutting accessory at a very low speed to position the cutting edge

within the cutting window.

WARNING: Read and understand the appropriate Stryker handpiece instructions for use.

Select Handpiece

Attachment

Select specific

attachment based

on the handpiece

capability.

Touch arrows to

scroll through and

highlight a

handpiece

attachment.

Program Handpiece Buttons

• Touch numbered button to assign

an option.

• Select specific options and assign

them to a particular handpiece

button based on handpiece

capability.