User's Manual

www.stryker.com 6390-009-001 REV B 31

Return To Table of Contents

Installation Guide

INSTALLING THE POWER-LOAD SYSTEM (CONTINUED)

14. Assemble the bumper block by aligning the supplied dead stop block (6390-001-244) (with through holes) (A)

with the supplied dead stop bumper (6390-001-243) (B) and the supplied inner dead stop block (6390-001-

246) (with threaded holes) (C) as shown in Figure 23.

15. Slide the assembled dead stop bumper into the end

of the transfer assembly.

Note: Position the dead stop bumper, so that the

hump (A) is on the bottom as shown in Figure 24.

16. Repeat steps 14-15 to assemble and install the

second dead stop bumper.

17. Using a 3/16” Allen wrench, install the four supplied

socket head cap screws (0004-662-000) (two for

each side) (D) into the transfer assembly as shown

in Figure 23.

Figure 23: Assemble Bumper Block

Figure 24: Dead Stop Bumper Hump